Organic and NPK fertilizer making machines

Four points on organic fertilizer equipment

1.The equipment should be installed on a horizontal concrete ground and fixed with anchor bolts. After installation, check whether the bolts at each part are loose and whether the door of main unit is fastened, if so, please tighten it. After the inspection, a no-load test run is performed. If the test run is normal, the production can be started. After the installation of the organic fertilizer equipment, the machine should be debugged to adapts the requirements of the fertilizer production.

Organic Fertilizer Production Line
2. It is not safe to check the organic fertilizer equipment without turning off the machine. For the convenience of the diagram, some operators check the machines directly. The important point is that the engine without turning off can easily cause a accident.
3. The water tank of the organic fertilizer equipment should be covered. Because the water in the tank always boiled and the lid must be shut down and cooled when adding cooling water. Inorder to save the time of removing the lid, many operators leave the water tank open to work so that a large amount of crop leaves and dust enter the inside of the water tank easily. And as the cooling water flows through the water pump to the body and cylinder head, it directly affects heat dissipation and causes the engine to overheat.
4. It is forbidden to wet the radiator. When many operators add water, they first pour water on the cover to reduce the temperature, which will wet the radiator. Some operators overflow the water when adding water. The water flows to the radiator fins. The air passage between the radiator fins is small and easy to be blocked by debris and dust. After being poured with water, the dust will stick to the radiator fin. The rapid reduction or blockage of the air passage area will reduce the heat dissipation effect, which will shorten the boiling time of the water tank and affect the operation.



Leave a Reply




Leave a message